FAMEX 5525 Professional Japanese Saw Kataba - Original Japanese Trim Saw 265 mm - Hand Saw Folding Saw Wood Saw - for The Demanding Users and Commercial

Traditional Japanese pull saw, with extremely good sawing performance, which protects the extremely sharp teeth. Original Shark Saw by Takagi & Co. From Japan. This saw is not a cheap replica, but the original with the highest cutting performance, quality and stability. The tensile cutting system: allows precise, straight and controlled cuts, easy start when sawing, precise, particularly precise cuts are possible, e.g. for producing flawless contact surfaces when sawing on mitre, shaving, manufacturing steps for overlapping gluing. Extremely thin saw blade, very low force when sawing, extremely good cutting performance. Special teeth: particularly clean cuts thanks to special Shark saw teeth. 3 cutting edges with 3 cutting Extremely sharp, diamond-ground tooth tips therefore significantly reduced "fraying" of the cutting edges none, or significantly lower risk of breaking out coatings or laminate, clean cutting surface, therefore no or significantly reduced post-processing, material: saw blade made of high-quality carbon steel, chrome-plated surface, the electronically impulse hardened teeth is extremely hard: 68-71HRC, allows up to 10 times the service life. the saw unfolded. T: 65 cm. Usable length of the saw blade: 26.5 cm

• Perfect saw: this saw is not a cheap replica, but the original with the highest cutting performance, quality and stability. The saw is made entirely in Japan from the handle to the saw blade. The Kataba Folding Saw is ideal for general sawing as well as more precise woodwork.
• The folding saw allows particularly precise, straight and controlled cuts. It works on the pull, which requires considerably lower effort. This gives the user more control over the saw and guarantees a much more accurate saw cut than conventional saws.
• The saw blade: the saw blade is extremely thin and flexible, which is why the folding saw is perfect for flush cuts. The 15 teeth per inch teeth are coarse enough to efficiently remove wood, but also fine enough to produce an accurate saw cut.
• The special "SHARK" saw teeth with 3 cutting edges are extremely sharp. The tooth tips are cut with diamonds. The chance of knocking frayed cut edges is minimised. Re-processing is rarely necessary.
• The material: made of high-quality carbon steel with chrome-plated surface. The electronically pulse-hardened teeth are extremely hard: 68-71HRC and guarantees a long service life.